Intelligent chip control, three stamping modes (pointing single press, long press continuous, automatic continuous, electronic counter (convenient counting, can be cleared to zero) comes with LED work light (to overcome the dark working environment). Two kinds of clutches 0.5/1/2T adopts general-purpose hexagonal cam ball clutch 1.5/3/4T adopts turn key clutch large tonnage punch press clutch structure, high-power foot switch oil seal waterproof, etc.. Each machine has gone through the “slider safety balance adjustment device” 5 debugging in through the percentage meter measurement.
Attention:
It is forbidden to overload the machine, and the impact force of the processed workpiece shall not exceed the limited range.
Machine lubrication points, as well as the friction parts, pay attention to diligent refueling, not less than 2 times per shift.
Before turning on the motor, the clutch must be disengaged and the flywheel in idle position.
Mold clamping must be accurate and firm. Reasonable gap between molds, often keep the edge of the mold sharp.
Often check whether the machine parts work properly, whether the connectors and fasteners are loose. If loose, tighten it in time. If you find that there is wear and tear of machine parts, must be replaced in a timely manner.
Machine and electrical devices must always keep clean, dry, no leakage phenomenon. In the work, such as found faults and anomalies, must immediately stop to check and repair. It is forbidden to work with disease, so as to avoid greater losses such as jamming of machine parts or burning of motor.
Regularly carry out comprehensive inspection and maintenance.
